Magnet Care

Thank you for choosing magnetic signs from SignEagle. Following these guidelines will give you years of trouble free service with your Magnetic Vehicle Signs.

FAILURE TO FOLLOW ANY OF THESE INSTRUCTIONS MAY RESULT IN DAMAGE TO THE MAGNETIC ITSELF AND TO THE SURFACE ON WHICH THE MAGNETIC SIGN IS AFFIXED, AND MAY ALSO INCREASE THE LIKELIHOOD THAT THE MAGNETIC WILL NOT ADHERE PROPERLY AND MAY FALL OFF DURING USE. NEITHER SIGNEAGLE.COM, OR ANY OF ITS AFFILIATES WILL BE LIABLE FOR ANY DAMAGES TO THE MAGNETIC SIGN OR THE SURFACE TO WHICH IT IS AFFIXED.

CLEAN AND CARE GUIDELINES

SURFACE PREPARATION:

The vehicle’s surface should be waxed a minimum of 48 hours prior to applying magnetic signs. For new vehicles or newly painted vehicles, allow approximately 90 days for the paint to totally cure before applying. Wipe the surface of the vehicle with a clean dry cloth before application and make sure that all grime, dust and dirt has been removed.

INSTALLATION:

Vehicle surface should be clean, dry and waxed prior to application. Make contact on one edge of the sign to the vehicle surface in the desired location, then gently allow magnetic to follow contour of vehicle until entire sign is held magnetically to vehicle. If positioning is not correct, remove entire magnet and repeat above process. Do not pull magnetic across vehicle surface as it may stretch the material and damage the vehicle.

Avoid placing magnetic over chrome trim or surface protrusions of any kind.

Magnetic should be 60 degrees Fahrenheit when installing.

REMOVAL:

Always remove the sign by lifting from the center of two opposite sides. Never start at the corners. This avoids bent corners and reduced adhesion.

MAINTENANCE:

Your magnetic should be periodically removed-once a week minimum. Wash and wipe dry the vehicle and back of magnetic. Trapped moisture, dirt or chemicals may harm your vehicle finish. Clean the magnet face with plain warm water.

STORAGE:

Do not store magnets with printed sides touching. It is recommended that magnetic signs be stored flat in order to prevent cracking and breaking. If stored rolled, a minimum 3" diameter core is recommended with the printed surface on the outside of the roll.

CAUTION:

Magnetic signs will not adhere to areas of a vehicle where plastic body fillers have been used. Use caution in applying magnetic to areas of vehicle that have been damaged or repaired.